The Best HP HPE6-A66 Study Guides and Dumps of 2022
Top HP HPE6-A66 Exam Audio Study Guide! Practice Questions Edition
NEW QUESTION 32
A customer is purchasing Aruba 555 APs for a new wireless network. The APs will be pre-staged as campus APs (CAPs) and be managed by a controller solution During the pre-staging process, console access to the APs might be necessary Which console connection cable should the customer purchase for the 555 APs?
- A. RS-232
- B. RJ-45
- C. USB-A
- D. Micro-B USB
Answer: D
NEW QUESTION 33
A customer placed an order for an ArubaOS 5406R switch and plans to rack mount it in a wiring closet. The dimensions of the switch are 17.5 inches wide (44.45 cm), 6.9 inches high (17.5 cm), and 17.75 inches deep (45.1 cm). How many rack units should a customer plan for this switch?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION 34
A customer requires Aruba switches that support Smart Rate ports to connect to Aruba APs Which switching product should the customer purchase that will provide 24 Smart Rate ports per access layer switch'?
- A. Aruba 2930F
- B. OfficeConnect 1950
- C. Aruba 2540
- D. Aruba 2930M
Answer: D
NEW QUESTION 35
A customer currently has sets of three Aruba 5406R switches deployed for an access layer in multiple wiring closets in a building They are clustered in a VSF domain The customer wants to set up Multiple Active Detection (MAD) for the OOBM port, as well as use this port for remote management access. To simplify the connectivity, the customer wants to connect these three switches' OOBM ports to a separate switch in the wiring closet for the OOBM connectivity.
Which would be the most cost-effective solution that would meet the customer's requirements?
- A. 2930M
- B. 2930F
- C. 5406R
- D. 0
Answer: D
NEW QUESTION 36
A high-end theater venue will be implementing an Aruba wireless solution using ceiling- and wall-mounted APs. The venue wants to ensure the the APs blend into the ceiling and wall environments. What solution should the customer use to ensure that wireless coverage is not hampered?
- A. Order Aruba AP covers for the APs
- B. Paint the APs to match the ceilings or walls
- C. Place the APs above the ceiling and behind the walls
- D. Place a strip of tape over the LEDs
Answer: C
NEW QUESTION 37
Which feature does the Aruba AP 555 support? (Select two.)
- A. high density indoor locations
- B. three radios
- C. weather proof and temperature hardened
- D. 802.11ac and lower standards only
- E. desk wall plate mounted
Answer: A,D
NEW QUESTION 38
A network architect imports a floorplan defined in a PNG file format What is the function of the measurement tool in Aruba's VisualRF?
- A. Define the appropriate dimensions of a Floorplan and Building View
- B. Define the appropriate dimensions of each object in a Floorplan View
- C. Define the appropriate dimensions of a Floorplan View
- D. Define the appropriate dimensions of each room in a Floorplan View
Answer: B
NEW QUESTION 39
A network architect has created two sites in IRIS and defined network devices for each site. From which window would a network architect connect the two sites together?
- A. Catalog
- B. Start Page
- C. Topology
- D. Site-1
Answer: D
NEW QUESTION 40
A network designer is documenting the number of physical sites for a customer that is within the scope of a redesign project. When determining the network purpose at each site, on what should the designer focus at each site? (Select two.)
- A. number of users
- B. square footage
- C. number of buildings
- D. ceiling height
- E. types of users and their devices
Answer: B,D
NEW QUESTION 41
Which must you perform in IRIS to assign a device to a Design Group?
- A. Drag and drop the device into the Design Group
- B. Right-click the device and select Set Layer Membership
- C. Right-click the device and select Set Design Group
- D. Drag and drop the device into the Site
Answer: A
NEW QUESTION 42
Which feature does the Aruba AP 387 support?
- A. 802.11 ax
- B. 60GHZRF
- C. included external directional antennas
- D. Indoor usage
Answer: B
NEW QUESTION 43
A customer has over 100 access layer switches. The customer requires user authentication done via the Aruba Dynamic Segmentation feature. What components are required to implement this solution? (Select two.)
- A. AirWave server
- B. enterpnse authentication server
- C. Active Directory server
- D. Aruba APs
- E. Aruba mobility controller
Answer: A,E
NEW QUESTION 44
NewStellar has a main corporate campus in a business park with two adjacent buildings. Each building has three floors and each floor is 322 x 175 feet (98 x 53 meters) for 56,350 square feet (5,235 square meters) total. The ceiling for each floor is 12 feet (3.6 meters) high with a drop-down ceiling at 10 feet (3 meters). The network architect has given you one floor to analyze, Building 1 Floor 2, shown in the attached exhibit.
This floor has a central main corridor with washrooms, stairs, elevators and supply and network cabinets. There are cubicles around the perimeter of the floor. The central part main corridor's dimensions contain 9,350 square feet (870 square meters). Assuming that wireless coverage is not required in the central area, which square footage (square meter) value should a network architect use when determining the number of APs in a capacity design for each floor?
- A. 56.350 square feet {5,235 square meters)
- B. 338,100 feet {31,410 square meters)
- C. 47.000 square feet {4,365 square meters)
- D. 55.750 square feet {5,175 square meters)
Answer: A
NEW QUESTION 45
A network architect is redesigning the access layer in a data center for a customer. The access layer requires fixed-port switches that support VSF and data center features like L2 VXLAN and REST-API Which switching solution should the network architect recommend?
- A. 0
- B. 1
- C. 2930F
- D. 3810M
Answer: C
NEW QUESTION 46
Which component uniquely defines the BSSID when implementing an employee SSID?
- A. Case-sensitive SSID name
- B. Wireless device MAC address
- C. Radio MAC address
- D. Case-insensitive SSID name
Answer: B
NEW QUESTION 47
A network architect has developed a design for a new Aruba Wi-Fi network that will include a virtual Mobility Master (MM) running the ArubaOS 8.4 operating system that will manage:
* Two clustered 7210 controllers with 600 campus APs
* Two clustered VMC-50 controllers with 75 remote APs
* Wireless IPS
The architect plans on creating user roles and firewall policies on the controllers as well as implementing AirMatch. What would meet the license requirements for this scenario?
- A. LIC-MM-VA-50 (X1), LIC-MC-VA-50 (x2). LIC-AP (X675), PEF (x675), RFP (X675)
- B. LIC-MM-VA-1000 (X1), LIC-MC-VA-50 (x2), LIC-AP (X675). PEF (X675). RFP <x675)
- C. LIC-MM-VA-1000 (X1). LIC-MC-VA-50 (X1), LIC-AP (x675). PEF (X675), RFP (X675)
- D. LIC-MM-VA-1000 (X1), LIC-MC-VA-50 (x1), LIC-AP (x600). PEF (X600), RFP (x600)
Answer: C
NEW QUESTION 48
A network architect is creating a new wired design for a warehouse building. As a best practice, what length should the architect allow for the service loop in the wiring closets in this environment?
- A. 3-10 feet (1-3 m)
- B. 15-30 feet (5-10 m)
- C. 30-60 feet (10-20 m)
- D. 3 feet (1 m)
Answer: D
NEW QUESTION 49
A company has two buildings on a campus that are approximately 700 feet (214 meters) apart with a clear line of site. No fiber exists between the buildings; however, there is a need for connecting the networks in the buildings together. The connection between the two buildings will need to support peak rates over 1 Gbps.
Which solution should the company choose that will meet their requirements as well as being cost-effective?
- A. Two outdoor AP 510s
- B. Two outdoor AP 367s
- C. Multi-mode fiber between campus switches
- D. Two outdoor AP 387s
Answer: B
NEW QUESTION 50
......
Understanding functional and technical aspects of Plan and design an Aruba solution percustomer requirements
The following will be asked from you in the HP HPE6-A66 dumps:
- Given a scenario, select the appropriate products based on the customer’stechnical requirements for a simple campus environment
- Given a customer scenario, explain how a specifictechnology or solution would meet the customer’srequirements
- Given the customer requirementsfor a single-site campus environment design the high-level Aruba solution
How to Prepare For Aruba Certified Design Associate Exam
Preparation Guide for Aruba Certified Design Associate Exam
Introduction
This exam validates you have a fundamental knowledge of an Aruba network design and know the Aruba product lines to help you design the network with the assistance of a senior designer. Candidate should know how to read a customer request and extract the information needed for a wired or wireless network. Candidate should know how to use VRF and IRIS. HP HPE6-A66 practice exams and HP HPE6-A66 practice test will help you to understand and memorize the concepts and detailed answers and solutions.
Candidate should give this exam who want:
- To position yourself as a trusted team member who can contribute to the design of enterprise-wide Aruba campus wired and wireless networks.
- To advance your career as a certified professional
- To validate you understand the fundamentals of designing an Aruba Mobile First Platform
Valid HPE6-A66 Exam Updates - 2022 Study Guide: https://www.passreview.com/HPE6-A66_exam-braindumps.html
HPE6-A66 Certification - The Ultimate Guide: https://drive.google.com/open?id=1RY9KpU7kArfjk3k--za54QCNxwUkyH3F