HP HPE6-A66 Cert Guide PDF 100% Cover Real Exam Questions
Pass HPE6-A66 Exam - Real Questions & Answers
For more info read reference:
HP HPE6-A66 Official Certification Site
NEW QUESTION 25
A customer has some employees that travel to various locations, where these employees will need Wi-Fi access at these locations. Because many of these locations do not have wireless support, the employees will need to carry an AP solution with them. Internet connectivity, if it doesn't exist at these locations, will be provided by a national phone company USB wireless card which will be connected to AP. The wireless solution needs minimal bandwidth, but needs to minimally support 802.1 lac wave 1 devices.
Which Aruba AP wireless solution would meet the needs of these employees most effectively and cost efficiently?
- A. 303H
- B. 203R
- C. 0
- D. 1
Answer: B
NEW QUESTION 26
A company needs an upgrade of its access layer switches. The solution requires that devices connected to the access layer by authenticated and their traffic processed by the firewall features of the Aruba Mobility Controllers. Which solution should the company implement?
- A. PAPI mobility
- B. iPsec tunneling
- C. Dynamic segmentation
- D. GRE tunneling
Answer: B
NEW QUESTION 27
A company is installing Internet of Things (loT) devices to support a smart and energy-efficient environment for a building, including loT devices for heating and air conditioning, lights, and window shades. loT devices of these types are typically classified as which category of devices?
- A. Highly mobile devices (HMD)
- B. Somewhat mobile devices (SMD)
- C. Stationary devices
- D. Nomadic devices
Answer: D
NEW QUESTION 28
A customer currently has sets of three Aruba 5406R switches deployed for an access layer in multiple wiring closets in a building They are clustered in a VSF domain The customer wants to set up Multiple Active Detection (MAD) for the OOBM port, as well as use this port for remote management access. To simplify the connectivity, the customer wants to connect these three switches' OOBM ports to a separate switch in the wiring closet for the OOBM connectivity.
Which would be the most cost-effective solution that would meet the customer's requirements?
- A. 0
- B. 2930M
- C. 2930F
- D. 5406R
Answer: A
NEW QUESTION 29
A network architect has developed a design for a new Aruba Wi-Fi network that will include a virtual Mobility Master (MM) running the ArubaOS 8.4 operating system that will manage:
* Two clustered 7210 controllers with 600 campus APs
* Two clustered VMC-50 controllers with 75 remote APs
* Wireless IPS
The architect plans on creating user roles and firewall policies on the controllers as well as implementing AirMatch. What would meet the license requirements for this scenario?
- A. LIC-MM-VA-1000 (X1), LIC-MC-VA-50 (x2), LIC-AP (X675). PEF (X675). RFP <x675)
- B. LIC-MM-VA-50 (X1), LIC-MC-VA-50 (x2). LIC-AP (X675), PEF (x675), RFP (X675)
- C. LIC-MM-VA-1000 (X1). LIC-MC-VA-50 (X1), LIC-AP (x675). PEF (X675), RFP (X675)
- D. LIC-MM-VA-1000 (X1), LIC-MC-VA-50 (x1), LIC-AP (x600). PEF (X600), RFP (x600)
Answer: C
NEW QUESTION 30
A network architect is given the task to design a new network solution for NewStellar Company, Inc. NewSteiiar has a main corporate campus in a business park with two adjacent buildings. The network architect has given one floor to analyze, Building 1 Floor 2, shown in the attached exhibit.
Each building has three floors and each floor is 322 x 175 feet (98 x 53 meters) for 56,350 square feet (5,235 square meters) total, which results in a total of 338,100 feet (31,410 square meters) for the entire building space. Each floor has a central main corridor with washrooms, stairs, elevators and supply and network cabinets. There are cubicles around the perimeter of the floor. The central part main corridor's dimensions contain 9,350 square feet {870 square meters).
Because of security concerns, video cameras will be installed throughout the facility. There are 16 of these per floor, 8 per wiring closet. The cameras are non-WiFi capable and require POE 802.3af-capable switch ports from which to draw power.
A wireless capacity design is required. Assuming that wireless coverage is required across the Building 1, Floor 2, including the central area, and that half the required APs will connect to each wiring closet, approximately how many POE+ ports will be required per wiring closet for all devices that have POE or POE+ needs?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: D
NEW QUESTION 31
A network architect will be using VisualRF to determine the appropriate wireless coverage for a new wireless design. Seamless, uninterrupted roaming is necessary for this design, since voice will need to be supported. Given these requirements, which information should be used in VisualRF to plan a cost effective solution that meets these requirements?
- A. Minimum -80db, 1 AP per 1,000 square feet, very high-density design
- B. Minimum -70db, 1 AP per 2,500 square feet, capacity design
- C. Minimum -70db. 1 AP per 5,000 square feet, high density design
- D. Minimum -65db, 1 AP per 2,500 square feet, high density design
Answer: D
NEW QUESTION 32
A network architect is replacing an old wireless implementation based on 802.11 a with a new wireless solution. The company has a lot of money invested in legacy wireless barcode scanners and will not be replacing them. However, the bandwidth that the company expects each AP to have less than 700 Mbps in bandwidth, and this is not expected to change in the future.
Which wireless solution would best meet this company's needs and be the most cost-effective?
- A. 802.11ax
- B. 802.11g
- C. 802.11n
- D. 802.11ac
Answer: A
NEW QUESTION 33
A network architect has created two sites in IRIS and defined network devices for each site. From which window would a network architect connect the two sites together?
- A. Start Page
- B. Catalog
- C. Site-1
- D. Topology
Answer: C
NEW QUESTION 34
A company has hired a network architect to replace an existing legacy wireless and wired network The building is one-story and contains four wiring closets Based on the information the network architect gathered from the company, one 48-port POE+ switch and three 48-port non-POE+ switches will be placed in each wiring closet. One stacking domain should be created for each wiring closet that supports 40 Gbps uplinks.
Which stacking solution should the architect implement for the floor that meets the requirements and is the most cost-effective'?
- A. VSX
- B. Backplane stacking
- C. Distributed trunking
- D. VSF
Answer: A
NEW QUESTION 35
A company needs to replace an existing legacy wireless and wired solution with one that supports features like 802 11 ax for APs and logical switching for switches. The company is located on a single floor with two wiring closets. Assume that there will be 10 APs connected via POE+ to each wiring closet, along with 36 wired user connections All switches on a floor should be configured in a single stack. The distance between wiring closets is 100 feet (31 meters).
Which switching solution will minimally provide 10 Gbps uplinks at the most cost-effective price, while still meeting the company's requirements?
- A. 3810M switches
- B. 2930F switches
- C. 5406R switches
- D. 2930M switches
Answer: D
NEW QUESTION 36
A network architect is redesigning a wireless network. The architect begins by analyzing the number of spatial streams supported by APs of various vendors as well as the wireless devices currently in the network, if the company wants to ensure that new wireless design, including user wireless devices, support Multi-User MIMO (MU-MIMO). which standard or standards must the wireless products support?
- A. Only 802.11ax,802.1lac, and 802.l1n
- B. Only 802.11ax,802.11ac, 802.11n, and 802.11a
- C. Only 802.11ax and 8011.ac
- D. Only 802.11ax
Answer: A
NEW QUESTION 37
A network architect is designing a Wi-Fi solution for a customer using Aruba Central's VisualRF tool When creating a Campus view, how would the network architect pull in a map that displayed the campus location in a city?
- A. Use VisualRF's built-in map tool and define the appropriate longitude and latitude information
- B. Import the longitude and latitude information from Google Maps
- C. Import the longitude and latitude information from any web-based map site
- D. Create a screen capture from any web-based map site and import the picture file
Answer: C
NEW QUESTION 38
A network architect is designing a new Wi-Fi solution for a customer The customer currently occupies a one-story building on a small campus. In one part of the building there is an auditorium, where the ceiling height and attenuation is different from the rest of the building. What should the network architect create in VisualRF to identify this difference when planning :ne APs?
- A. Define the appropriate properties in the Building View
- B. Spit the Building View into two Floorplan Views
- C. Define the appropriate properties in the Network View
- D. Create a Region in the Floorplan View
Answer: A
NEW QUESTION 39
A high-end theater venue will be implementing an Aruba wireless solution using ceiling- and wall-mounted APs. The venue wants to ensure the the APs blend into the ceiling and wall environments. What solution should the customer use to ensure that wireless coverage is not hampered?
- A. Place the APs above the ceiling and behind the walls
- B. Order Aruba AP covers for the APs
- C. Place a strip of tape over the LEDs
- D. Paint the APs to match the ceilings or walls
Answer: A
NEW QUESTION 40
......
100% Free HPE6-A66 Daily Practice Exam With 60 Questions: https://www.passreview.com/HPE6-A66_exam-braindumps.html
Pass HPE6-A66 Review Guide, Reliable HPE6-A66 Test Engine: https://drive.google.com/open?id=1eTU3nWdEc98peqbr_doigZ_bZzbYt3SE