Assume Huawei H35-561-ENU Dumps PDF Are going to be The Best Score [Q27-Q42]

Share

Assume Huawei H35-561-ENU Dumps PDF Are going to be The Best Score

HCNP-LTE RNP & RNO H35-561-ENU Exam and Certification Test Engine

NEW QUESTION 27
In the LTE protocol specification, which of the following protocol layers is not included in Layer 2?

  • A. PDCP
  • B. MAC
  • C. RLC
  • D. NAS

Answer: D

 

NEW QUESTION 28
Which of the following release cause values will be counted as E-RAB abnormal release?

  • A. UE Not Available for PS Service
  • B. Inter-RAT Redirection
  • C. Unspecified
  • D. Om-Intervention

Answer: C

 

NEW QUESTION 29
Which network element use to trigger third party registration during an IMS user registration process?

  • A. PCRF
  • B. I-CSCF
  • C. P-CSCF
  • D. S-CSCF

Answer: D

 

NEW QUESTION 30
At the current stage, which of the following can trigger a handover within the LTE system?

  • A. RSSI
  • B. CQI
  • C. RSTQ
  • D. RSRP

Answer: D

 

NEW QUESTION 31
The maximum bandwidth supported by carrier aggregation in the R12 protocol is 50 MHz.

  • A. True
  • B. False

Answer: B

 

NEW QUESTION 32
In the LTE system, which of the following criteria is used for cell selection?

  • A. Srxlev >0 or Squal >0
  • B. Srxley >0
  • C. Squal >0
  • D. Srxlev> 0, and Squal> 0

Answer: D

 

NEW QUESTION 33
Which of the following scenarios need to use the RIM process?

  • A. Redirection
  • B. CSFB
  • C. Flash CSFB
  • D. PS handover

Answer: C,D

 

NEW QUESTION 34
Regarding the T310 timer, which of the following descriptions is wrong?

  • A. If the security is not activated after the timer expires, the RRC enters idle state, otherwise, the RRC connection establishment process is initiated.
  • B. Receive N311 continuous synchronization, indication from the lower layer, trigger the corresponding handover process, and stop when initializing the connection re-establishment process
  • C. During the operation of the T310 timer, if the wireless link recovers, stop the timer, otherwise it will run all the time. Once the timing expires, the wireless link is considered to be failed.
  • D. When the physical layer problem is detected, it is turned on, that is, the receiving the indication that N310 is continuously out of sync, and from the lower layer.

Answer: A

 

NEW QUESTION 35
Which of the following KPI indicators are in the retention category?

  • A. Call drop rate
  • B. Paging success rate
  • C. RRC connection establishment success rate
  • D. Resource block utilization

Answer: A

 

NEW QUESTION 36
Regarding N311 and N310, which of the following descriptions are correct? (Multiple choice)

  • A. N311 indicates the maximum number of consecutive "synchronous" indications received from the underlying layer
  • B. N310 indicates the maximum number of consecutive "synchronous" indications received from the underlying layer
  • C. N310 indicates the maximum number of consecutive "out of step" indications received from the underlying layer
  • D. N311 indicates the maximum number of consecutive "out of step" indications received from the underlying layer

Answer: A,C

 

NEW QUESTION 37
Which of the following randomly access scenarios are competition-based scenarios? (Multiple choice)

  • A. Initial access in idle mode
  • B. RRC reconstruction after radio link out of synchronization
  • C. Upstream out-of-synchronization state requires uplink data transmission
  • D. Switch to the new community
  • E. Upstream out-of-synchronization state requires downlink data transmission

Answer: A,B,C

 

NEW QUESTION 38
With regard to measurement events, which of the following are correct?

  • A. A4 event: The quality of the adjacent area is above an absolute threshold. Used for switching between frequencies.
  • B. A3 event: The quality of the neighboring cell is higher an absolute threshold than the quality of the serving cell. For intra-frequency/inter-frequency coverage-based switching.
  • C. A2 event: The quality of the serving cell is below an absolute threshold. Used to turn on inter-frequency measurements and activate gap
  • D. A1 event: The quality of the serving cell is above an absolute threshold. Used to turn off ongoing inter-frequency measurements and gaps.

Answer: A,B,C,D

 

NEW QUESTION 39
Which of the following was announced by SRB0 carried?

  • A. RRC Connection Request
  • B. RRC Connection Setup
  • C. RRC Connection Reestablishment
  • D. RRC Connection Setup Complete

Answer: A,B,C

 

NEW QUESTION 40
Which of the following parameters need to be set in PRACH parameter planning? (Multiple Choice)

  • A. Phone type
  • B. Root sequence index
  • C. Cell high speed identification
  • D. Cyclic displacement index

Answer: B,C,D

 

NEW QUESTION 41
Which of the following information will be issued through "RC Connection Reconfiguration"? (Multiple Choice)

  • A. Switch command
  • B. SRB1 establishment
  • C. Measurement configuration information
  • D. Default bearer DRB establishment information

Answer: A,C,D

 

NEW QUESTION 42
......

Use H35-561-ENU Exam Dumps (2022 PDF Dumps) To Have Reliable H35-561-ENU Test Engine: https://www.passreview.com/H35-561-ENU_exam-braindumps.html