[2022] 700-905.pdf - Questions Answers PDF Sample Questions Reliable
Cisco 700-905 Dumps PDF Are going to be The Best Score
Cisco 700-905 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
NEW QUESTION 21
Which two processes does Disk Failure initiate? (Choose two)
- A. Distributed pooled data is migrated off nodes to master data store.
- B. The affected cluster is marked as unhealthy and placed into standby mode
- C. Self-healing mode is initiated and data replication factors applied.
- D. If the replication factor is sufficient for the failure, the system is marked as unhealthy but remains
operational - E. Performance is almost unaffected Sets 1-minute timer until self-healing starts.
Answer: C,E
NEW QUESTION 22
When local writing or reading is performed, the lOVisor intercepts the read/write requests and forwards them
to CVMs across the cluster This action allows non-local CVMs to be aware of the input/output requests so that
they can perform the appropriate input/output action lOVisor provides which two additional functionalities?
(Choose two.)
- A. when an lOVisor fails, the CVM remains active and functional, which enables uninterrupted operation
of the system by forwarding 10 to another available lOVisor In the HyperFlex cluster - B. intercepts local virtual machines' reads and writes and distributes them across the network eliminating
hotspots - C. integration point for deployment of cloud-based SaaS offerings from eco-system partners
- D. provides redundancy when local CVM fails, offloading data processing to another CVM in the cluster
- E. enables asynchronous replication of data across individual HyperFlex nodes with sub-second
re-convergence
Answer: A,E
NEW QUESTION 23
There are often disadvantages when using mixed hardware, and uniform systems are highly advised. What are
three disadvantages of using validated yet mixed hardware? (Choose three.)
- A. Validated yet "mixed" hardware systems may be supported by the
specific original equipment manufacturers but software vendors require a master level services
agreement. - B. "Software only" solutions are inherently more secure, adhering to government regulations.
- C. "Software only" solutions can result in a lack of simplicity for installation and maintenance. While setup
and maintenance of an HCI solution might be simple you still need to configure and maintain the
hardware part, which is not orchestrated by the HCI solution. - D. "Software only" HCI solutions often mean that HCI vendors do not have control over the hardware that
the consumer is using. The lack of control over the hardware can result in hardware not being
security-compliant (usually the case with white box solutions) or not being optimally configured for the
given HCI solution. - E. Validated hardware does not mean smooth performance, which particularly applies to hardware that is
seldom chosen for the hardware part of the "software only" solution. - F. "Hardware only" solutions require less latency for data aggregation.
Answer: A,E,F
NEW QUESTION 24
Which two steps should be performed before installing HyperFlex? (Choose two.)
- A. Determine and download recommended hypervisor
- B. Download service profile templates
- C. Complete the pre-installation checklist.
- D. Determine and download virtual machine OS! required
- E. Determine and download recommended installer OVA version required
Answer: C,E
NEW QUESTION 25
When cabling a given HX node to the Fabric Interconnect which three actions are required?
(Choose three.)
- A. Connect the node to the same port number on each of the two Fabric Interconnects.
- B. Connect server port L1 to Fabric Interconnect port L1.
- C. Connect server port L2 to Fabric Interconnect port L2
- D. Connect port 2 on the VIC to Interconnect B
- E. Connect port 1 on the VIC to Fabric Interconnect A.
- F. Connect the node to different port numbers on each of the two Fabric Interconnects.
Answer: A,D,E
Explanation:
NEW QUESTION 26
Which two components are automatically configured from the information provided to the HyperFlex installer? (Choose two )
- A. operating system deployment preparation
- B. controller VM configuration
- C. server firmware policy
- D. application dependencies
- E. the network
Answer: B,E
NEW QUESTION 27
Which two features enable RAID cards striping as well as mirroring and parity? (Choose two.)
- A. Hot replacement of drives available, depending on configuration
- B. Integration with Cisco Intersight for a cloud-based storage management solution.
- C. On RAID card failure, the RAID onboard concurrent cache assists rebuild cache.
- D. Distributed drives across disparate systems can be in RAID together.
- E. No load on the system resources, drives seem as one drive to the operating system
Answer: A,E
Explanation:
NEW QUESTION 28
Which version of HXDP was the first to support multiple VICs on a single server?
- A. HXDP 4.0
- B. HXDP 3.0
- C. HXDP 3.5.1
- D. HXDP 3.5
Answer: C
Explanation:
NEW QUESTION 29
HyperFlex compute nodes contribute what percentage of the overall disk storage capacity?
- A. 0%
- B. 10%
- C. 20%
- D. 5%
Answer: A
Explanation:
NEW QUESTION 30
How many PCIe standards-compliant interfaces do Cisco VICs support?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
NEW QUESTION 31
How many separate VLANs must each HyperFlex node be configured with running ESXi?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
Explanation:
NEW QUESTION 32
Which three advantages of using the M5 generation of HyperFlex servers over the M4 generation are valid? (Choose three )
- A. Support for Cisco VICs
- B. M.2 SATA drive support for faster disk I/O
- C. Microsoft Hyper-V support
- D. Multiple GPUs
- E. NVMe support
- F. DDR3 memory
Answer: B,C,E
Explanation:
NEW QUESTION 33
How many PCIe standards-compliant interfaces do Cisco VICs support?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: C
Explanation:
NEW QUESTION 34
In all HX server types, where are capacity drives installed?
- A. back
- B. front
- C. top
- D. side
Answer: B
NEW QUESTION 35
Which two results are expected when you replace a node or expand a cluster? (Choose two.)
- A. Distributed pooled data is migrated off nodes to master data store.
- B. The cluster profile is updated and RAID takes care of rebalancing the load.
- C. vSphere DRS migrates the virtual machines to the new node to balance the load
- D. Affected node is marked as unhealthy and placed into standby mode
- E. On node replace, the self-healing must finish for the cluster to be healthy
Answer: C,E
Explanation:
NEW QUESTION 36
Which three configurations for read caching in Cisco HyperFlex are valid? (Choose three.)
- A. Write-through (install option for VDI): Only most commonly used data is cached: optimizing VDI performance
- B. Battery-Initiated Read-back (default): Only read data and most commonly used data are deposited in the Level 4 read-back cache
- C. Level 4 cached (SSD): With semi-flash nodes; there is a large difference in read speeds between SSDs
- D. Write-back (default): Only write information and most commonly used information are deposited in the cache
- E. No caching (SSD): With all-flash nodes; because there is little difference in read speeds between SSDs
- F. Write-first (default for VDI): Infrequently used data is cached: freeing system resources for VDI performance
Answer: A,D,E
Explanation:
NEW QUESTION 37
......
Use 700-905 Exam Dumps (2022 PDF Dumps) To Have Reliable 700-905 Test Engine: https://www.passreview.com/700-905_exam-braindumps.html